Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Aug 9, 2007 12:41:45 GMT -5
Would anyone have a Blind bearing removal tool that I might borrow? I have to remove the axle bearing from the rear end housing on the Recon. The I.D. on the bearing is 1 1/8 inches. Thank Marko
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Aug 9, 2007 15:00:35 GMT -5
Marko I have most any type of bearing puller that you may require. Give me a call 413-8515, Danny
|
|
|
Post by Bob T on Aug 9, 2007 17:26:46 GMT -5
Marko, I believe Blind bearings require a Braille tool.
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Aug 10, 2007 20:40:02 GMT -5
Marko, I believe Blind bearings require a Braille tool. Oh, that was low, hi Bob
|
|
|
Post by sonyamc on Aug 14, 2007 20:33:01 GMT -5
Shawn says if it's the pinion bearing - get it out the best way you can because of the locking ring on it. If it's the carrier bearings, heat up the aluminum and they will fall out. Or do what I did and get someone else to do it for you!!! LOL Peace!
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Aug 15, 2007 19:39:35 GMT -5
Thanks to Danny Brown for the loan of a bearing puller. The right tool got the job done in seconds. Thank Danny Marko
|
|